The storage methods for different types of steel are also different. The specific storage methods can be read in the following content, hoping to help everyone:
1. The site or warehouse for storing colored steel coils should be located in a clean and unobstructed area, away from factories and mines that produce harmful gases or dust. Weeds and all debris should be removed from the site to keep the steel clean
2. Do not stack acid, alkali, salt, concrete, and other raw materials that adhere to stainless steel plates in the warehouse. Different types of stainless steel plates should be stacked separately to avoid confusion and avoid contact corrosion.
3. Large and medium-sized channel steel, guide rails, thick steel plates, large diameter steel pipes, and cast steel parts can be stacked outdoors.
4. Large, medium, and small channel steel, wire rods, building steel bars, medium seamless steel pipes, stainless steel wires, and galvanized steel wire ropes can be stored in arches with good natural ventilation and must be opened and closed.
5. Some small and medium-sized stainless steel plates, cold-rolled steel plates, square pipes, steel chains, ferrite cores, caliber or thick walled seamless steel pipes, various cold-rolled and cold-drawn stainless steel plates, and their high cost metals can be stored in warehouses.
6. Warehouse selection should be based on natural geographical standards. Usually, a general enclosed warehouse is used. The existing warehouse has a roof and a courtyard wall.
7. The warehouse regulations require attention to natural ventilation on sunny days, waterproofing on rainy days, and frequent maintenance of a suitable natural storage environment.
8. Reasonable stacking and first in, first out.
1) The principle requirement for stacking is to stack according to varieties and specifications under stable and safe conditions. Different types of materials should be stacked separately to prevent confusion and mutual corrosion.
2) It is prohibited to store items that have corrosive effects on steel near the stacking position.
3) The bottom of the pile should be raised, sturdy, and flat to prevent moisture or deformation of the material.
4) The same type of materials are stacked separately according to the order of storage, facilitating the implementation of the principle of first in, first out.
5) The steel sections stacked in the open air must have wooden mats or stones underneath, and the stacking surface must be slightly tilted to facilitate drainage. Attention should be paid to placing the materials straight to prevent bending and deformation.
6) The height of the stack shall not exceed 1.2m for manual operations, 1.5m for mechanical operations, and 2.5m for stack width.
7) There should be a certain passage between the stacks, with an inspection passage of generally 0.5m. The entry and exit passage depends on the size of the material and transportation machinery, which is generally 1.5-2.0m.
8) The pile bottom should be raised by 0.1m if the warehouse is on a cement floor in Chaoyang; If it is muddy ground, it must be raised by 0.2~0.5m. If it is an outdoor site, the cement floor should be raised by 0.3-0.5m, and the sand and mud surface should be raised by 0.5-0.7m.
9) The angle steel and channel steel stacked in the open air should be placed vertically, with the mouth facing downwards. The I-shaped steel should be placed vertically, and the I-groove surface of the steel should not be facing upwards to prevent water accumulation and rust.
How Do Manufacturers Store Different Colored Steel Coils?
Sep 10, 2023
Leave a message




